How to Wall Mount a Flat Screen TV

In recent years they have been given a massive increase in demand for LCD TVs Plasma, which seem to be getting thinner, lighter and more powerful. There are several good reasons for new pirchasing an HDTV, such as displaying superior high-definition clear, affordable and energy savings. These new designs to slimmer LCD HDTVs and plasma ideal for wall mounting. Not only wall mounting your TV free up valuable space in your living room, but you can add an element of aesthetic appeal to your home cinema setup. Here are some suggestions on how to successfully mount your screen. Before you begin any of the mounting hardware you need to decide on the best position to mount the TV. Careful planning is required as a wall mount an HDTV is very much a permanent solution will be integrated into the design of your home. You should consider the placement of your furniture, the overall theme of your room, potential viewing angles and better positioning of audio quality. Once you think you have chosen a suitable site which should have a piece of cardboard or wrapping paper and cut the size of the TV screen. You must then approach the placement, by recording the sheet of cardboard or paper to the wall where the screen is placed then mark with a pencil. Remove the bracket on the back of the screen if still connected, then stayed on TV is expensive. Next you need to locate the four mounting in the back of the TV and remove the screws. Once done you must remove the mounting arms or the mounting plate wall mount packaging. To attach the mounting arms, need to align vertically and parallel to each other by using the mounting holes in the back of television. Make sure they are in perfect alignment and bolt guns with the supplied bolts and washers that should have come with the wall mount. If you are using a mounting plate, then it is very easy to align the holes with the mounting holes on television. Locate the wall studs that are closest to the required position on the screen using a stud finder and mark them with a sharp pencil. Now you have to remove the wall mount packaging. Align the wall mount to the studs in the center of the marked position that determined above. No matter if it is not perfectly centered on wall brackets can be adjusted horizontally at a later time. Using a spirit level, align the wall mount and mark the position where the screws go. Drilling in the next Asparagus, which are approximately 1 "deep. The size of the drill should be used will be determined by the size of the screws supplied with wall bracket. The wall bracket to the wall with screws provided and washers, however, did not tighten the screws completely. Adjust the position of the horizontal wall mount until you are satisfied with the alignment. Once you are satisfied with the position of the screen you are free to tighten the screws on the rest of the way . Attatching the screen to the wall mount requires two people. Simply lift the TV and connect it to the wall. At this point, you will still be able to adjust the horizontal position to the position of the screen perfectly. Once the desired position has been acquired you need to make tighten the arms or the mounting plate to the wall.